1.Panel Clip Remover Pliers
The most common tool for removing plastic screw rivets is a panel clip remover plier tool. This is a small, hand-held tool with a claw on one end and a screwdriver. The claw end is used to pry the rivet out of the hole, and the screwdriver end is used to remove the rivet from the tool.
The problem with a pop rivet removal tool is that it can be challenging to get a good grip on the rivet. If you don’t have a good grip, you risk damaging the surrounding plastic.
2.Use A Screw
Some plastic screw rivets have a Phillips head on them.
However, you can’t easily unscrew them with a Philips screwdriver.
If you take a pointed screw that is slightly bigger than the rivets head, then you can pull it.
Take the screw and twist it into the plastic rivet head to do this. Once it is tight into the head, you can pull the rivet out.
3.Hammer Claw
A common method is by using a hammer claw. It is similar to using a pop rivet tool, but not everyone has a pop rivet tool handy. So instead, if you have a hammer with a claw on it, you can work underneath the plastic rivet and pull it out.
4.Needle Nose Pliers
Another option is to use need nose pliers. These are common tools to have in your toolbox, and they can be effective at removing plastic screw rivets.
The pliers have a small, pointed end that can fit into the rivet hole. You can then use the pliers to twist and pull the rivet out.
Be careful with this method, as you can easily break the rivet off if you’re not careful.
5.Small Flat-Head Screwdriver
You can try to use a small flat-head screwdriver. This is one of the least effective methods because it is hard to grasp the rivet. However, it may be your only option if you don’t have any other tools.
The flat head screwdriver method works well with the needle-nose pliers. You can lift the head of the rivet and grab it with the pliers to pull it out.
Remember to take your time and be careful not to damage the surrounding plastic.
6.Drill
Lastly, you can drill it out if the rivet does not come out after trying any of the methods listed above.
This is the last resort because you risk damaging the surrounding plastic. If you do have to drill the rivet out, use a tiny drill bit that is slightly smaller than the rivet’s head.
Drill into the rivet head until the bit goes all the way through. Once the drill bit is through the other side, use a pair of pliers to pull the rivet out.
“Keyword”
“how to remove plastic rivets”
“plastic rivet removal pliers”
“plastic push rivet removal tool”
“how to remove plastic push pins”
“how to remove plastic rivets jeep”
“bmw plastic rivet tool”
“how to remove toyota plastic rivets”
“plastic rivets for cars”
